-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueCreating a Culture of Collaboration
PCB designers could learn quite a bit from NASA and the private companies that develop spacecraft: Every one of these vehicles is a testament to the value of collaboration among disparate stakeholders. Without a collaborative culture, the rocket might never get off the ground.
Breaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Surface Finishes for High-Speed PCBs
The Nickel Doesn’t Make Cents!
PCB surface finishes vary in type, price, availability, shelf life, assembly process, and reliability. While each treatment has its own merits, electroless nickel immersion gold (ENIG) finish has traditionally been the best fine pitch (flat) surface and lead-free option for SMT boards over recent years. But unfortunately, nickel is a poor conductor with only one third the conductivity of copper. Also, nickel has a ferromagnetic property that can adversely affect electromagnetic fields in the high-frequency domain.
The PCB industry has addressed the issue of the ferromagnetic properties of nickel by introducing a nickel/gold (NiAu) alloy. Gold is slightly less conductive than copper, and has no ferromagnetic properties, so it has relatively little impact on the conductor's loss characteristics at high frequencies.
Microstrip (outer) layers of a multilayer PCB suffer from wide variations in both trace width and thickness. This is due to the additional fabrication process of electroplating the through-holes. Copper barrel thickness is generally specified as a minimum of 1 mil (25.4 µm), and so extra copper plating is applied to the surface in order to produce the correct barrel wall thickness. This, unfortunately, is also added to the traces. But as the thickness and width varies, so does the impedance. This is one of the reasons why routing controlled impedance signals, on the microstrip layers, should be avoided.
It is also very important not to pour copper fills on the signal layers of the board, as these will dramatically change the impedance of the traces rendering the impedance control ineffective.
Read the full column here.
Editor's Note: This column originally appeared in the June 2014 issue of The PCB Design Magazine.
More Columns from Beyond Design
Beyond Design: Dielectric Material Selection GuideBeyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities